How to Fix Elf Bar BC5000 Burnt Taste: A Complete Guide.


To fix elf bar bc5000 burnt taste, clean the device thoroughly and switch to a new coil. Elf bar bc5000 is a disposable vape pen that offers convenience and portability to smoke enthusiasts.

However, it can sometimes develop a burnt taste due to certain reasons like overused coil, low-quality e-juice, or insufficient e-liquid level in the tank. Vape pens should not taste burnt, and it can be frustrating for consumers. This article will educate you on how to fix elf bar bc5000 burnt taste in a few simple steps.

So, stick around!

How to Fix Elf Bar BC5000 Burnt Taste: A Complete Guide.


Understanding The Causes Of Burnt Taste

Overview Of Burnt Taste

If you’ve been vaping with a elf bar bc5000, you may have experienced a burnt taste. This unpleasant flavour occurs when the coil overheats and burns the e-liquid instead of vapourizing it. In this section, we will explore the causes of burnt taste, including the factors that influence it and the negative effects on your vaping experience.

Factors That Influence Burnt Taste In Elf Bar Bc5000

Several factors affect the likelihood of experiencing a burnt taste when vaping your elf bar bc5000 device. These include:

  • Lack of e-liquid–when there is not enough e-liquid in the tank, the coil can become dry, causing the burnt taste.
  • A worn-out coil–when the coil is used for an extended period, it wears out, and the burnt taste occurs.
  • High wattage–increasing the wattage on the device above the recommended range for the coil can cause the liquid to overheat and create the burnt taste.
  • Chain vaping–using the elf bar bc5000 constantly without allowing it to cool down can cause overheating of the coil resulting in a burnt taste.

The Negative Effects Of A Burnt Taste

Experiencing a burnt taste when vaping can have several negative effects on your vaping experience, including:

  • Harshness–a burnt taste can make it difficult to inhale, harsh and uncomfortable, leading to coughing and throat irritation.
  • Unpleasant flavour– burnt taste is not a flavour anyone would like to experience. It can make the vaping experience undesirable and discourage vaping altogether.
  • Coil damage– experiencing a burnt taste continuously can shorten the lifespan of your coil resulting in the need for frequent replacement.

Understanding the causes of burnt taste is essential, so you can avoid the negative effects of this problem. In the next section, we will look at how you can fix the elf bar bc5000 burnt taste to enjoy a better vaping experience.

Evaluating Your Elf Bar Bc5000 And Identifying The Root Cause Of Burnt Taste

If you’re experiencing a burnt taste on your elf bar bc5000, it can be frustrating and distracting from your vaping experience. However, there might be different reasons causing it, from clogged atomizer to incorrect wattage settings. Evaluating your vape device and identifying the root cause of burnt taste can help you fix the issue and enhance your vaping experience.

Follow the below steps to know more about how to fix your elf bar bc5000 burnt taste in this comprehensive guide.

Checking If Atomizer Needs Cleaning

The first step in identifying the burnt taste in your elf bar bc5000 is to check if there’s a need for cleaning in your atomizer. Over time, atomizers become clogged with dirt that can burn your coil and cause burn taste.

Follow the below steps for cleaning your atomizer.

  • Remove the atomizer from your vape device.
  • Disassemble the atomizer by removing the coil, wick and tank.
  • Use warm water to rinse the atomizer to remove any dirt or debris.
  • Soak the atomizer for 15-20 minutes in white vinegar or alcohol to dissolve any remaining dirt.
  • Rinse the atomizer thoroughly again with warm water and let it dry overnight.
  • Reassemble the atomizer and insert it back into your elf bar bc5000.

Inspecting The Coil And Wick

Another reason you might be experiencing burnt taste in your elf bar bc5000 is due to the coil or wick not functioning correctly. Coil and wick get worn out over time and need replacing every so often. Follow the below steps to inspect the coil and wick of your elf bar bc5000.

  • Remove the atomizer from your elf bar bc5000.
  • Disassemble the atomizer by removing the coil and wick.
  • Inspect the coil for any dark spots or damage.
  • Replace the coil if it is damaged or burnt out.
  • Inspect the wick for any frayed or burnt spots.
  • Replace the wick if it is damaged, frayed, or burnt.

Identifying The Right Wattage

Another common reason you might be experiencing burnt taste is if you’re operating your elf bar bc5000 on the wrong wattage setting. If the wattage is too high, it will burn your coil and wick, causing burn taste. Follow the below steps to identify and adjust your wattage settings.

  • Check the recommended wattage range for your coil on the packaging or manual.
  • Check your elf bar bc5000 wattage setting and ensure it’s within the recommended range.
  • Adjust the wattage setting to the appropriate level if it’s too high or too low.

Verifying The E-Liquid Level

Finally, the e-liquid level might be the culprit causing burn taste on your elf bar bc5000. If the e-liquid level is too low or too high, it can cause a burnt taste. Follow the below steps to verify your e-liquid level.

  • Check the e-liquid level on your elf bar bc5000.
  • Refill your e-liquid if it’s too low using the recommended e-liquid type and flavor.
  • Check if the e-liquid flow is not interrupted by a clogged atomizer or coil.

If you’re experiencing burnt taste on your elf bar bc5000, there’s no need to worry. Evaluating your device and identifying the root cause of burn taste can help you fix the issue and enjoy your vaping experience again. Follow the steps outlined above to ensure your device is clean, the coil and wick are functional, the wattage is adjusted properly, and the e-liquid is at the required level.

Fixing The Burnt Taste Of The Elf Bar Bc5000

The elf bar bc5000 is a popular vaping device known for its excellent flavor delivery. However, like any other vaping device, it’s common to experience a burnt taste over time. This burnt taste is caused by several reasons, including a dirty atomizer, a damaged coil, or incorrect wattage settings.

In this guide, we’ll explore the best ways to fix the burnt taste of your elf bar bc5000.

Cleaning The Atomizer

  • Remove the atomizer from the device and disassemble it.
  • Rinse all the parts under warm water and let them dry properly.
  • Avoid using tap water, as it may contain minerals and impurities that can damage the atomizer.
  • Once dry, reassemble the atomizer and screw it back into the device.
  • Prime the coil by adding a few drops of e-liquid onto each cotton hole or letting it sit for 10-15 minutes before using the device.

Replacing The Coil And Wick

  • Unscrew the atomizer and remove the coil from the base.
  • If the coil is damaged or worn out, discard it and replace it with a new one.
  • Remove the wick by gently pulling it out, disposing of it before inserting a new one.
  • If your device uses pre-built coils, simply replace the old one with a new one.
  • After replacing the coil and wick, prime the coil with a few drops of e-liquid before using the device.

Adjusting The Wattage Settings

  • Low wattage settings are ideal for less powerful coils and resistances
  • High wattage settings require powerful coils and resistances.
  • Adjust the wattage settings to the resistance and coil you’re currently using.
  • Lower wattages work better, especially if you’re experiencing a burnt taste.
  • Adjust the wattage settings in small increments until the device stops producing the burnt taste.

Refilling The E-Liquid

  • Always check the e-liquid level before vaping to ensure it’s not empty.
  • If empty, refill the tank with your preferred e-liquid flavor.
  • Make sure to prime the coil after refilling the e-liquid to avoid dry hits and burnt tastes.
  • Fill the tank to the recommended level, to prevent any dry hits from occurring
  • Priming the coil will ensure that the cotton absorbs the e-liquid faster, preventing dry hits that may produce a burnt taste.

With the above techniques, you can easily fix the burnt taste of your elf bar bc5000. Regularly cleaning the atomizer, replacing the coil and wick, adjusting wattage settings correctly, and refilling your e-liquid properly will ensure you experience the best flavor with your vaping device.

Preventing Burnt Taste In Elf Bar Bc5000

Best Practices To Avoid Burnt Taste

To prevent burnt taste in your elf bar bc5000, you should practice the following best practices:

  • Take short puffs: By taking shorter puffs, you will give your device time to wick properly. Long puffs cause the wick to dry out and result in burnt taste.
  • Lower wattage: When you use your elf bar bc5000 at high wattage, it produces more heat than the coil can handle, resulting in burnt taste. Thus, it’s better to use a lower wattage for a longer lifespan of the coil.
  • Priming the coil: Priming means saturating your new coil with e-liquid to prevent burning. It’s good to prime your coil before vaping and let it sit for a few minutes to soak up juice thoroughly.

Regularly Cleaning And Maintenance

Performing proper cleaning and maintenance is vital to maintain the elf bar’s optimal performance.

  • Keep it clean: Dirt and debris can affect the flavor of e-liquid, so wipe your device properly and keep it clean.
  • Cleaning the tank: Disassemble the tank and rinse it with warm water. Dry and clean it thoroughly before reassembling the tank.
  • Change the coil: If you continue to experience burnt taste, it might be time to replace the coil. The coil can get clogged over time with debris and e-liquid buildup.
  • Check for any damage: Check for any damage to the device, and replace any broken parts.

Correct Storage Of Elf Bar Bc5000

Storing your elf bar bc5000 properly can also prevent burnt taste.

  • Keep it away from heat and sunlight: Exposure to heat and sunlight can damage your device. Hence, keep it stored in a cool, dark place.
  • Upkeep e-liquid levels: If you want to store your elf bar bc5000 for a long period, make sure to remove the e-liquid to avoid gunk build-up.
  • Store it upright: The best way to store your elf bar bc5000 is upright to prevent any e-liquid leakage.

Choosing High-Quality E-Liquids

Choosing the right e-liquids can also help you prevent burnt taste in elf bar bc5000.

  • Research and choose quality e-liquids: Quality e-liquids are essential for a good vaping experience. So, research and choose e-liquids that use high-quality ingredients.
  • Avoid overuse of e-liquid: Overloading your device with e-liquid can cause burnt taste. So, ensure that you’re using only the right amount of e-liquid for your coil, which you can check in the instruction manual of your device.
  • Avoid e-liquids with high sweeteners: Avoid e-liquids with high sweeteners because they tend to be thicker and clog up the coil faster, causing burnt taste.

Frequently Asked Questions For How To Fix Elf Bar Bc5000 Burnt Taste

How Do I Stop My Elf Bar Bc5000 From Tasting Burnt?

To fix a burnt taste from your elf bar bc5000, try cleaning the device, adjusting the power level, and using a new coil. Additionally, ensure that you are properly priming your coil before using the device.

Why Is My Elf Bar Bc5000 Tasting Burnt?

The most common reasons for a burnt taste in your elf bar bc5000 include: a dirty device, dry hits, overuse of your battery, using a low-qualify e-liquid or having a coil that needs to be replaced.

How Often Should I Replace The Coil In My Elf Bar Bc5000?

You should replace the coil in your elf bar bc5000 every 1-2 weeks depending on your usage habits and the type of e-liquid you’re using. A clogged or burnt coil can drastically affect your vaping experience.

How Do I Properly Prime My Elf Bar Bc5000 Coil?

To prime a coil on your elf bar bc5000, start by dropping a small amount of e-liquid onto the cotton inside of the coil before screwing it onto the base. Next, fill the tank with e-liquid and wait a few minutes before using the device.

How To Clean Elf Bar Bc5000?

To clean your elf bar bc5000, start by disassembling the device and placing the tank under warm running water. Then, use a toothbrush or soft cloth to gently scrub the tank. Finally, let the device dry completely before reassembling.


Fixing a burnt taste from an elf bar bc5000 isn’t as daunting as you may have thought. There are several reasons why this can happen. Fortunately, with the steps we have provided above, you’ll be back to enjoying your vaping experience in no time.

Remember to check the atomizer’s condition, temperature, and e-liquid levels regularly. Cleaning your device regularly will also help you avoid this issue. If the issue persists, consider seeking help from a professional. At the end of the day, a burnt taste issue is a minor inconvenience considering the benefits vaping has to offer.

So don’t let these little setbacks discourage you from experiencing the joy of vaping. With these simple steps, you’ll be able to fix your burnt taste and continue vaping as usual. Happy vaping!

Latest articles


Related articles

Leave a reply

Please enter your comment!
Please enter your name here